Image
image
image
image


CUBIC .... wall mounted enclosure


Cubic Wall Enclosures are designed for indoor and outdoor applications, where floor space is limited, or when wall-mounting would be beneficial. The encloses are suitable for a wide range of applications, including housing termination / patch panels for routing cabling within a communications / data network, or in more industrially orientated installations, for housing control equipment linked to continuous process machines. The latter units typically require RFI screening to protect the equipment from emissions generated by the manufacturing process. A glass door enables LED’s or monitors to be viewed without opening the unit.

 

 

CONSTRUCTION
Standard sizes are available to suit most equipment configurations, and RFI shielding capability enables screening from emissions and immunity to prevent conflict with other equipment. The extensive choice of sizes makes it easy for equipment manufacturers to build product families sharing a uniform appearance and image. All paneling is trapped within the extrusion by an IP55 environmental rubber seal, which prevents rattling.
UPGRADEABLE EMC SCREENING
The EMC screening is achieved through gaskets fitted in-board of the IP seals. The gaskets are therefore protected from any moisture contamination. The level of screening can be increased by reducing the interval between each gasket, so finely tuned screening levels can be achieved without incurring the costs of unwanted higher performance. The screening level achieved is 40dB from 100MHz up to 500MHz.
DUST AND SPLASHPROOFING TO IP55
The range complies with IP55 ingress protection standard, with snugly fitting rattle-free covers that protect against dust and water ingress (when subjected to low pressure water jets from all directions).
EARTHING UP TO CLASS 1
Cubic’s design provides impressive integral strength as well as highly efficient bonding. Specially designed corner joints allow full LVD approved earth bonding, via the joints. Up to Class 1 bonding can be specified, providing sufficient earth protection to house an open-framed PSU. Earthing at each corner also enhances the shielding performance and avoids the need for earth wires, which can snag and make a unit unsafe.
VARIABLE DEPTH MOUNTING

Variable-position front and rear equipment amounting uprights, permit recess mounting, if required. Angle supports can be added to independently support heavier equipment. Solid or glass doors can be hung to left or right, top or bottom and with 180°opening for total access.

FEATURES
EMC
IP55
Plinth
Recess MT6
Earth Class 1
Door 180°
Tip up feet
Handle
WALL ENCLOSURE
-
-
-
Height
W = 19” x DEPTH
300
400
500
600
800
4U
435000
435001
 
6U
435002
435003
 
7U
435004
435005
 
9U
435006
435007
 
12U
435008
435009
 
16U
435010
435011
 

 

Notes on sizes

Height - Internal where 1U = 44.45mm

Width - Internal mounting for standard 19" 84HP or 10.5" half width 42HP

Depth - Overall External

Other sizes on request.

Data sheet

 

Full range of accessories

 
Tel:
+44(0)1279 635500
Fax:
+44(0)1279 635282
eMail:

 

 



Contact us | View site map


image


image
image